CONTACT US 800-292-5565 or [email protected]
While Republic Diesel’s specialty is repairing components using the thermal coatings discussed in the spray metalizing section, our general machine department is capable of repairing or making new several types of components. Our shop lathes can swing parts 60 inches in diameter or slightly more than 14 feet in length. Our CNC horizontal boring mill has a 55”x60” rotary table that can travel 98″x70″x47″x19”. Our shop is equipped with several lathes, surface, mills, surface grinder and drill presses. We have our critical measuring tools calibrated to assure the best quality product possible.
Spray Welding
Republic Diesel has been using the Thermal Coating process to repair engine components, transmission, torque and brake components for several years. This repair process is authorized by many manufacturers to repair various components. The two primary processes we use are the thermal spray arc system and the powder flame spray process. We successfully repair components that range from a couple of inches in diameter up to 60 inches in diameter. We have applied the thermal coating to spindles and hubs in large earth moving equipment as well as repairing a seal surface of a bearing race diameter on small splined shafts.
- Cylinder block restoration
- Main caps spray-welded to restore interference fit
- Main saddles spray welded to repair damaged bores
- Crankshaft seal areas
- Big bore end on connecting rod
- Driveline yoke seal area
Internal transmission and torque components including:
- Brake Anchors
- Brake Pistons
- Aluminum Torque Converter-Impellors
- Stators
- Turbines
- Yokes
- Steering Clutch Pistons
Spray Weld Preparations
- Preparing and masking
- Spray weld repair
- Applied repair before resurface
- Resurfaced decks
Cylinder Block Repair
- Complete and thorough checkout including magnetic particle inspection and pressure testing
- All critical dimensions measured, recorded, and compared to OEM specifications, repairs estimated accordingly
- Fabricate and install brass water passage repairs to repair erosion of the parent metal
- Spray welding of deck surfaces worn below minimum height requirements
- Deck resurfacing done with inserts to meet OEM surface finish criteria on numerically controlled Rottler mill machine
- Cylinders bored from 2” to 24” diameters
- Resurfacing capabilities up to 104” in length
- Cylinder blocks resurfaced and bored in same set up
- Additional repairs include installing upper and lower bushings, lifter bore and cam bore repairs, and align bore
Crankshafts and Camshafts
- Magnaflux Inspections for Crack Detection
- Wet magnetic particle inspection
- Inspect for hardness and straightness
- Polish and grind crankshafts
- Indexing and stroke equalizing
- Plugs removed and oil galleys cleaned
- Seal areas repaired by spray welding
- Profilometer – surface finish gauge
- Snout repair, machine keyway, and gear installation capabilities
- Remanufactured crankshafts exchanged and sold
Connecting Rod
- Complete Recondition
- Replace pin bushings
- Magnetic particle inspection
- Recondition rod housing bore
- Spray weld rod housing bore
- Internally grind rod housing bore
- Check center to center, bend, and twist
- Replace pin bushings